Difference between revisions of "Nanoscribe Photonic Professional GT"
Jump to navigation
Jump to search
| Line 13: | Line 13: | ||
| NEMO_Designation = LW-02 | | NEMO_Designation = LW-02 | ||
| Lab_Phone = XXXXX | | Lab_Phone = XXXXX | ||
| − | | SOP Link = [https:// | + | | SOP Link = [https://wiki.nano.upenn.edu/wiki/images/d/d4/LW-02_SOP.pdf SOP] |
}} | }} | ||
| Line 31: | Line 31: | ||
===== SOPs & Troubleshooting ===== | ===== SOPs & Troubleshooting ===== | ||
| − | * [https:// | + | * [https://wiki.nano.upenn.edu/wiki/images/d/d4/LW-02_SOP.pdf QNF SOP] |
* [https://support.nanoscribe.com/hc/en-gb NanoGuide] | * [https://support.nanoscribe.com/hc/en-gb NanoGuide] | ||
Revision as of 09:37, 29 September 2025
 |
|
| Tool Name | Nanoscribe Photonic Professional GT |
|---|---|
| Instrument Type | Lithography |
| Staff Manager | Ana Cohen |
| Lab Location | Bay 6 |
| Tool Manufacturer | Nanoscribe |
| Tool Model | Photonic Professional GT |
| NEMO Designation | LW-02 |
| Nearest Phone | XXXXX |
| SOP Link | SOP |
Description
The Nanoscribe Photonic Professional is an easy-to-operate table-top laser lithography system that enables the fabrication of true three-dimensional nanostructures using commercially available photoresists. Designed for the fabrication of photonic crystal structures, the instrument is also ideal for, e.g., generating three-dimensional scaffolds for biology, micro- and nanofluidic circuitry.
Key Features
- Laser power: 50-150 mW, Wavelength: 780 nm, Pulse ~100 fs, Repetition rate: 80 MHz
- Available for Conventional 3D printing mode, Dip-in Liquid mode and air mode
- 3D printing with lateral resolution ~ 200 nm, vertical resolution ~ 300 nm
- High-precision Piezo scanning range: 300 x 300 x 300 μm3
- Motorized XY-scanning range: 100 x 100 mm2
Resources
SOPs & Troubleshooting
Training Protocol
- Remote session on EBL-02 for the Describe conversion software, using your structure (90min)
- In-person session on LW-02 (120min)
- Qualification session on LW-02, where you run the tool with minimal input (~60min) -- must be done after previous two sessions are completed, cannot be done the same day as the in-person training