ABM3000HR Mask Aligner
 |
|
| Tool Name | ABM 3000HR Mask Aligner |
|---|---|
| Instrument Type | Lithography |
| Staff Manager | Eric Johnston |
| Lab Location | Soft Lithography |
| Tool Manufacturer | ABM |
| Tool Model | 3000HR |
| NEMO Designation | {{{NEMO_Designation}}} |
| Lab Phone | 3-9639 |
| SOP Link | SOP |
Description
The ABM Mask Aligner is a manual and versatile mask aligner with top-side alignment and substrate capabilities from 100mm down to small pieces. Requires a 5" mask or 5" glass plate with film mask.
Applications
MA-03 Mask Aligner Calibration SOP TJV 8/23/22
(1) Intial front panel settings: a. POWER switch: off b. INTENSITY Meter: WATTS c. CURRENT/VOLTS: VOLTS d. C/P Mode e. All 5 knobs turned counterclockwise f. Shutter closed (2) Turn on Power switch (3) Depress Start button and hold it in to start the lamp. (Be patient) (4) Give 5 minutes for the power meter to read the proper wattage (5) Use knob below mode to adjust wattage to desired setting (300ish) (6) Open Shutter and measure intensity using external powermeter (7) Set intensity/power switch to intensity (8) Adjust calibration knob until intensity/power meter reading equals the intensity measured on external device (be patient, let it have some time before adjusting). Lock CAL knob (9) Set Mode to C/I (10) Adjust set knob to desired intensity and Lock knob.
NOTE:
- Our set knob seems to have a decaying sensor. Sometimes, it cannot be used to adjust intensity. In this case:
o Follow steps (1)- (6)
o Continue in C/P mode and use the knob under mode to adjust the intensity to desired value.
o 350watts should give 20 on the power meter in Channel A. If it requires more than that, we most likely need a new bulb. 350 watts is at the top range of capability.
Resources
SOPs & Troubleshooting
- SOP: SOP
- Video for basic tool use (no audio, 5.52min):Basic Video
- Video (LayoutEditor - negative resist alignment marks): Video
- The potentiometer for the inspection microscope light source on the MA-03 is a bit touchy, so only adjust the intensity if needed. If you find that adjustments make the light turn off, press down lightly as you rotate back and forth until you get it working again.